EB TECHNOLOGY START-S2XL Instrucciones Y Advertencias Para El Instalador página 46

10
4.00 Program of the DIPA to exclude the connections
The control unit dispose of micro-switches DIPA and DIP B and DIPC which can activate or deactivate different functions to give
more safety.
Dip 1
1 2 3 4
Dip 2
1 2 4
3
Dip 3
4
1 2 3
Dip 4
1 2 3 4
4.01 Program of the DIP B for the sequence START
This sequence is for the control START connected to the terminal board no.16 and for the programming of the remote controls.
To deepen go to the chapter " REMOTE COLTROLS"
Dip 1 ON
1 2 4
3
Dip 1 OFF Dip 2 ON
1 2 3 4
Dip 1 OFF Dip 2 OFF
1 2 3 4
Dip 1 ON
1 2 4
3
To memorize the working time and the pause time with time acquisition "real time " see chapter " Memorization of the working time"
Dip 3
1 2 3 4
Dip 3
1 2 3 4
Dip 4
1 2 3 4
Dip 4
1 2 4
3
4.02 Program of the DIPC for BUS-DATA SYSTEM. Courtesy light
Dip 1 - 4
1 2 3 4
Dip 1
1 2 3 4
ON It excludes the connection of the Opening Limit Switch . And vice versa
ON It excludes the connection of the Closing Limit Switch. And vice versa
ON It excludes the connection of STOP. And vice versa
ON It excludes the connection of PHOTO-BEAMS. And vice versa
Dip 2 OFF COLLECTIVE USE
PARTIALLY
AUTOMATIC
AUTOMATIC 1
Dip 2 ON AUTOMATIC 2
ON
It activate the " Man Present " Up function ( with a remote control ,too)
OFF
It deactivate the " Man Present " and it works the working sequence of the dip1 and 2.
ON
It activate the standard working time at 90 seconds with a pause time of 10 seconds.
OFF
It deactivate the standard working time and it use the working time previously programmed .
Free program to create an address to control the control unit,
For Bus data System see next chapters.
IN the output of the terminal board no. 3 and 4 there is tension available from
ON
the beginning of the closing up to 2 minutes after closing.
It is important to power the courtesy light.
When opening and in pause time it doesn't accept any other control.
It recloses automatically at the end of the pause time
Each control the sequence is: open-stop-close-stop-open ETC.
It doesn't reclose automatically.
Each control it inverts: open-close It reclose automatically
at the end of the pause time.
Each control the sequence is open-stop-close-stop-open.
It recloses automatically at the end of the pause time.