EDELRID SERIUS HEIGHT WORK Manual Del Usuario página 13

EN
SERIUS HEIGHT WORK
INFORMATION ON USE, SAFETY, LIFESPAN, STORAGE
AND CARE
This product is part of personal protective equipment
(PPE) and should be assigned to a specific person. These
instructions for use contain important notes, a control
card and a proof of inspection (test book).
Before using this product, all documents must have been
read and their content understood.
This document must be provided to the user by the retail-
er in the respective country's language and must be kept
with the equipment while it is in use.
Instructions for use
These instructions must be carefully read and followed.
This product has been manufactured especially for work-
ing at heights and in depths and does not release the user
from any personal liability.
Mountaineering, climbing and working at heights and in
depths often harbour hidden dangers and risks caused by
external influences. Risk of accidents must never be ex-
cluded. In order to achieve maximum safety when moun-
taineering, climbing and working at heights and in depths,
safe use of equipment is only guaranteed if it complies
with industrial norms.
For more detailed and comprehensive information,
please refer to relevant special literature.
The following instructions are important to ensure appro-
priate and correct use of the equipment. However, they
cannot replace experience, responsible behaviour and
awareness of the risks inherent in mountaineering, climb-
ing and working at heights and in depths and do not re-
lease the user from any personal responsibility. Use of the
equipment is only permitted to fit and experienced indi-
viduals or under appropriate guidance and tuition.
Users must be aware that poor physical and mental
health can jeopardise safety under normal conditions and
in emergencies.
Before using the equipment, users must familiarise them-
selves with safe and effective rescue procedures.
The manufacturer cannot be held liable if the equipment
has been abused or used incorrectly.
All risks and responsibilities are borne by the user at all
times.
When using this product in the areas of rescuing and
personal protective equipment, we recommend that the
relevant national regulations be observed.
PRODUCT-SPECIFIC INFORMATION
Specification
This product meets obligatory requirements of EN 397,
except for the retention system.
The retention system has a strength of at least 50 daN,
and elongation of the whole system is not longer than 25
mm (requirement of EN 12492).
Additionally the product meets optional requirements of
EN 397: Protection against impact under low temperature
-30°C.
This product meets obligatory requirements of ANSI/
ISEA Z89.1-2014 Type I Class G.
Fitting
To provide safe protection, this helmet must be adapted
to the head size of the user. The safety helmet must be
adjusted to head size in such a way so that it cannot shift
or slip off when the chin strap has been tightened. This is
the only way to ensure protection from the helmet. The
helmet is only secure when the chinstrap is closed, the