Westfalia SIARR 51-08 Manual Del Usuario página 2

SIARR
51 - 08
PREPARATION
* Dismantle and remove the tow ring on the left hand side.
* Locate the bumper fastenings corresponding to the holes marked Z
in the tow bar, dismantle and remove them.
* Drop the exhaust silencer down.
* Also remove the bumper end plugs to enable you to subsequently
tighten all of the nuts, bolts and screws in Y.
ASSEMBLY
* Fasten the right and left arms to the outside of the vehicle's
longitudinals using fastening kit Y, without tightening.
* Position the tow bar crosspiece and fasten it under the vehicle
using fastening kit Z, without tightening.
* Fasten the arms on to the crosspiece using fastening kit W.
FINISHING
* Tighten all of the nuts, bolts and screws to the torques indicated below.
FASTENING KIT
2 off HM16x45 screws
2 off DEC16 washers
V
2 écrous M16
2 cache écrous
1 tow ball
4 off HM12x40 screws
W
6 off CS12 washers
2 off M12 nuts
Z 2 off 7/16 nuts
2 off 12-35 plain washers
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
2 off HM12x100 screws
X
2 off M12 screws nylstop
4 off HM12x40 screws
Y
4 off CS12 washers
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM5108-E - FOLIO NDM ANG
Type Type
Approval No.
Tow-bar for
e11*94/20*00*0536
Jeep Wrangler
post 1997 models
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
342120600001
Max. Total Max. Total Max. Verti-
Authori. Weight Towable Weight cal load
2 100 kg 2 000 kg
Value
D
80 kg 10,05 kN