Assembly; Joining The Stand And The Control Unit - Sony BKM-38H Manual De Instalación

Assembly

Joining the Stand and the Control
Unit
You can join a control unit to a monitor, using the
attachment stand.
1
1 Fit the control unit into the projection of the
attachment stand to join them together.
2 Attach the left and right stands to the sides of the
control unit, using two screws C (4 × 16) each.
Left stand
2
Connect the supplied connecting cable to the DC 5V/
12V IN and LAN (10/100) connectors on the rear panel
of the control unit.
Note
Be sure to plug the female connector of the cable onto
the DC 5V/12V IN connector on the control unit.
Connect the
female connector
to the control unit.
3
Attach the left and right covers to the stands, using four
screws A (3 × 8) each.
14
Assembly
4
Attach the plates or joints to the stands to suit the
models.
For PVM-L2300 monitor
Engage the notches of the left and right stands in the
projections on the bottom of the plates and fix them
securely using two screws B (4 × 8) each.
Right stand
Screw C
For BVM series monitors
Place the joints on the left and right stands and fix them
securely using two screws B (4 × 8) each.
Plate
Screw B
Front of the
control unit
Joint
Rear of the
control unit
Screw A
Plate
Screw B
Joint