LUND Revolution Bull Bar Manual De Instalación página 3

10. Reinstall the air dam using the factory hardware. NOTE: It may be necessary to loosen the bracket
hardware to reinstall the air dam.
11. Reinstall the Bull Bar as described in Step 7.
12. Level and adjust the Bull Bar and fully tighten all hardware.
13. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Bull Bar.
Front
(Fig 1) Driver/left mounting location
pictured from behind bumper
Driver Side Installation Pictured
(2) 8mm x 35mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
Front
8mm Bolt Plate
8mm Plastic Retainer
(Fig 3) Driver/left side Frame Bracket layout
8mm Bolt Plate
8mm Plastic Retainer
Front
(Fig 2) Insert Bolt Plate back
through bumper bracket (arrow)
8mm Flat Washer
8mm Lock Washer
8mm Hex Nut
Page 3 of 4
I-Sheet Number I-20261 Rev.A
REVOLUTION BULL BAR
2019 RAM 1500
Remove the (2)
factory hex bolts
08/14/18 (DP)