Further Information - Hilti AG 100-7 Manual De Instrucciones Original

5.2 Further information

Maximum disc diameter
Permissible peripheral speed
for grinding and cutting discs
Max. grinding disc thickness
Max. cutting disc thickness
Thread diameter
Thread length
Weight in accordance with
EPTA procedure 01/2003
5.3 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one electric tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information in accordance with EN 60745
Sound (power) level (L
Emission sound pressure level (L
Uncertainty for the sound pressure level
(K )
pA
Total vibration (vector sum of three directions), measured in accordance with EN 60745
Other applications, such as cutting, may produce vibration values that deviate from the given values.
Surface grinding with the
vibration-absorbing side handle (a
Uncertainty (K)
6 Before use
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and
when troubleshooting.
6.1 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.2 Fitting or removing the guard
▶ Observe the instructions for fitting the applicable guard.
22
AG 100-7 S/D, AG 100-8 S/D
100 mm
80 m/s
6.4 mm
2.5 mm
M10
11 mm
1.9 kg
) 101 dB(A)
WA
) 90 dB(A)
pA
3 dB(A)
6.5 m/s²
)
h,AG
1.5 m/s²
AG 115-7 S/D, AG 115-8 S/D
115 mm
80 m/s
6.4 mm
2.5 mm
M14
15 mm
2.0 kg