Greenlee 555C Manual De Instrucciones página 16

Bending Instructions (cont'd)
Offsets
1. Measure the height and length of the obstruction.
Select the angle to be used.
2. See the Offset Table. The height of the obstruc-
tion must be equal to or greater than the minimum
offset.
3. Refer to the X Table to find the X dimension. Refer
to the Offset Table to find the center-to-center
distance.
Note: If the center-to-center distance is not shown,
calculate it by using the multipliers shown in the
Offset Table.
4. Mark the conduit as shown.
5. Insert the conduit into the bender. Align Mark 1 with
the front edge of the hook and bend the conduit.
6. Align Mark 2 with the front edge of the hook.
Without removing the conduit from the bender,
rotate the conduit 180°. Make the second bend.
LENGTH
X
MARK 1
CENTER TO CENTER
DISTANCE
LENGTH
HEIGHT
OBSTRUCTION
Greenlee Tools, Inc.
Offset Table
15°
Center-to-Center
30°
Center-to-Center
45°
Center-to-Center
15°
Center-to-Center 46-3/8
30°
Center-to-Center
45°
Center-to-Center 16-15/16 19-13/16 22-5/8 25-7/16 28-1/4 31-1/8
CENTER-TO-CENTER DISTANCE = OFFSET HEIGHT x MULTIPLIER
OFFSET
ANGLE
MARK 2
MULTIPLIER
Figures are approximate
X Table
CONDUIT SIZE
"X"
Figures are approximate
16
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
555C Electric Bender Classic
2 4
OFFSET }
Max. Conduit
3/4 1-1/2
Size
7-3/4 15-7/16
Max. Conduit
3/4
Size
8
Max. Conduit
Size
OFFSET } 12 14
Max. Conduit
Size
54-1/16 61-13/16 69-9/16 77-1/4
Max. Conduit
Size
24 28
Max. Conduit
1-1/2
Size
10° 15° 22-1/2°
5.8 3.9
1/2 3/4 1
3-1/16 3-1/16 3-3/16
6 8 10
2
23-3/16 30-15/16 38-5/8
1 1-1/2 2
12 16 20
1/2 1 1-1/4
8-1/2 11-5/16 14-1/8
16 18 20 22
2
85
2
32 36 40 44
2
30° 45°
2.6 2.0 1.4
1-1/4 1-1/2 2
4 4-1/4 4-1/2