Important Safety Information - Greenlee 555C Manual De Instrucciones

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this warning will
result in severe injury or death.
Do not use this tool in a hazardous
environment. Hazards include flam-
mable liquids, gases, or other materi-
als. Using this tool in a hazardous
environment can result in a fire or
explosion.
Failure to observe this warning will
result in severe injury or death.
Greenlee Tools, Inc.
SAFETY
ALERT
SYMBOL
555C Electric Bender Classic
Electric shock hazard:
• Connect the power cord to a
120 volt, 20 amp receptacle on a
ground fault protected circuit only.
See "Grounding Instructions."
• Do not modify the power cord or
plug.
• Inspect the power cord before
use. Repair or replace the cord if
damaged.
• Disconnect from power before
servicing.
Failure to observe these warnings
could result in severe injury or death.
• Do not expose to rain.
• Do not use in wet or damp
locations.
Failure to observe these warnings
could result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Do not remove guards.
Failure to observe this warning could
result in severe injury or death.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070