Handle Removal And Replacement; Transportation - Greenlee 555C Manual De Instrucciones

Handle Removal and Replacement

The handle of the 555C is designed to be removable.
This feature is convenient when performing complex
bending, and makes it easy to replace a damaged
handle.
Removal
1. Place the bender in the upright position.
2. Release the spring clip on the safety snap pin (79).
3. Remove the pin from the handle (80) and the sleeve
of the frame (1).
4. Repeat Steps 1 through 3 for the other end of the
handle.
5. Lift the handle to remove.
Replacement
1. Insert the handle (80) into the sleeves of the
frame (1).
2. Align the holes in the handle with the holes in the
sleeves.
3. Insert the safety snap pin (79). Ensure that the pin
goes through the handle and the sleeve on the
frame (1).
4. Engage the safety spring clip over the end of the
pin. Ensure that the loop on the clip is completely
around the pin.
5. Repeat Steps 2 through 4 for the other end of the
handle.
80
1
79
Removing or Replacing Handle
Greenlee Tools, Inc.
555C Electric Bender Classic

Transportation

Make sure that the handle is properly installed and
secured with the safety spring clips and snap pins
before lifting or moving the bender. An improperly
installed handle could allow the bender to fall, injuring
nearby personnel.
Failure to observe this warning could result in severe
injury or death.
Remove the shoe unit from the main shaft and storage
spindle and remove all roller support units from the
bender. The only proper way to lift this bender is by
looping a nylon or polyester sling around the storage
spindle and main shaft to create a sling as shown. The
sling should extend between the handle and main frame
of the bender so that the handle acts as a guide for the
sling, as shown below.
Securely attach the lifting device to the sling and make
sure all components used to lift this bender are properly
rated for 159 kg (350 lb) weight. Use a ramp to load and
unload from a truck or other vehicle that is not equipped
with a lift gate.
Transporting Bender
27
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070