Installing The Refrigerator - Haier QNE27J Serie Manual Del Usuario

INSTALLATION INSTRUCTIONS
INSTALLING THE REFRIGERATOR - FRENCH DOORS
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
Sides 1/8" (3 mm)
Top 1" (25 mm) Cabinet/Hinge Cover
Back 2" (50 mm)
WARNING
Follow all steps. Failure to follow these
instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and
property damage.
IMPORTANT NOTES
When removing french doors:
• Read the instructions all the way through before starting.
• Place the screws by their related parts to avoid using them
in the wrong places.
• Provide a non-scratching work surface for the doors.
CAUTION
Lifting Hazard.
Single person lift can cause injury. Use assistance when
handling, moving or lifting the refrigerator doors.
NOTE: When moving door, to prevent damage to door
and electronics carefully place the door in a proper
location.
WARNING
To eliminate the risk of electric shock or injury during
installation, you must first unplug the refrigerator before
proceeding. Failure to follow these instructions can result
in electrical shock.
Tape the doors shut with adhesive tape.
12
1. REMOVING DOORS (Right)
A. Remove the hinge cover on
top of the right fresh food
door by removing the screw
using a Phillips screwdriver.
B. Using a 5/16" socket ratchet/
driver, remove the bolts
securing the top hinge to
the cabinet. Lift the hinge
support straight up to free
the hinge pin from the socket in the top of the door.
C. Remove the tape from the right door and tilt the door
pin.
D. Set the door on a non-scratching surface with the
inside up.
2. REMOVING DOORS (Left)
A. Remove the hinge cover on
top of the left fresh food door
by removing the screw using a
Phillips screwdriver.
B. Unplug the 3 wire connectors
and move the wires until you
can see the screws holding the
hinge.
C. Using a 5/16" socket/ratchet driver, remove the bolts
securing the top hinge to the cabinet.
Wire Connectors
Bolts
Wire Connectors
ENGLISH
49-60806