Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
For assistance with your tool, visit our website at www.porter-cable.com for a list of service
centers, or call the Porter-Cable Customer Care Center at 1-888-848-5175.
MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be
cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are making
good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. No further lubrication is necessary.
BRUSH INSPECTION (If applicable)
For your continued safety and electrical protection, brush inspection and replacement
on this tool should ONLY be performed by an AUTHORIZED PORTER-CABLE SERVICE
STATION or a PORTER-CABLE•DELTA FACTORY SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest authorized Porter-
Cable Service Station to be thoroughly cleaned and inspected. Have worn parts replaced
and lubricated with fresh lubricant. Have new brushes installed, and test the tool for
performance.
Any loss of power before the above maintenance check may indicate the need for immediate
servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS CONDITION.
If proper operating voltage is present, return your tool to the service station for immediate
service.
14
Publicidad
Tabla de contenido
