Mounting Plates And Earth-Continuity Plates - Weidmuller Klippon POK EX Instrucciones De Montaje

Mounting plates and earth-continuity plates

The electrical potential of the mounting plate and the cable entries can be
connected through the earth-continuity plates (grounding plates) at the base
of the enclosure.
When using the ½ earth-continuity plates, you can establish a connection
to the mounting rail by using an earthing ring (refer to Cable Gland
Accessories).
(The installation instructions can be found in the Appendix.)
You can also use the continuous earthing bolt (M6/M10).
The holes in the enclosure must precisely match the holes
in the earth-continuity plates so that the IP protection is not
compromised.
Article designation, enclosures
KLIPPON POK 080806 EX
KLIPPON POK 081106 EX
KLIPPON POK 081606 EX
KLIPPON POK 081906 EX
KLIPPON POK 082306 EX
KLIPPON POK 121209 EX
KLIPPON POK 122209 EX
KLIPPON POK 161609 EX
KLIPPON POK 162609 EX
KLIPPON POK 163609 EX
KLIPPON POK 165609 EX
KLIPPON POK 252512 EX
KLIPPON POK 254012 EX
KLIPPON POK 256012 EX
KLIPPON POK 404012 EX
KLIPPON POK 252516 EX
KLIPPON POK 254016 EX
28
Mounting plate
9510570000
9510580000
9510680000
9510690000
9510700000
9510590000
9510600000
9510610000
9510620000
9510630000
9510710000
9510640000
9510650000
9510660000
9510670000
9510640000
9510650000
½ COPL
1390910000
1390920000
1390930000
1390940000
1390950000
1390970000
1390980000
1390990000
1391000000
1391010000
1391020000
1391030000
1391040000
1391050000
1391070000
1391030000
1391040000