Charging The Headphones - Gioteck FL400 Manual De Instrucciones

USING THE PORTABLE SPEAKERS
(BLUETOOTH MODE)
To use the External Speaker function in Bluetooth mode, please follow
this procedure;
1] Disconnect the 2 fixed audio cables from the headband and both of
the earcups.
2] Remove the earcups from the headband by carefully pulling them
away from the Headband housing.
3] When the earcups are disconnected from the headband, use the
provided 3.5mm audio cable to connect the left and right earcup
speakers together through the fixed audio cable ports on the top of
the earcups.
4] To enable the External Speaker Mode, hold the left earcup multi-
function button for 2 Seconds. To change back to headphones mode
hold the left earcup multi-function button for 2 Seconds.
01
02
11
Audio Connector Jack for
Headphone/external Speaker
HOLD
04
03
3.5MM
Audio Cable

CHARGING THE HEADPHONES

1] To charge the Headphones, use the supplied USB cable and insert into
any powered USB Port. Normal charging process takes 2-3 hours.
2] The red LED on the left Earcup will turn on when charging and will
turn off when charging is complete.
3] Make sure the battery has been fully charged and fully released at the
first three times of use to ensure the battery the best performance.
After charging is complete, please remove the cable from the
Headphones and the USB Cable from the USB port.
Do not keep the Headphones connected to the USB port for a long time
when charging complete as this will shorten the lifetime of the Battery.
12