Lithium-Ion Battery - Briggs & Stratton 090000 Manual De Instrucciones

• Store away from furnaces, stoves, water heaters or other appliances that have pilot
lights or other ignition sources because they can ignite fuel vapors.
When Storing Battery Pack
• Keep battery charger dry. Avoid exposing battery pack to rain or wet conditions.
Fuel System
See Figure: 17, 18
Note: Some models have a fuel tank for vertical storage that will let the engine tilt for
maintenance or storage (C, Figure 17). Do not store in vertical position with fuel tank filled
above the bottom of the fuel level indicator (D), if equipped. For further instructions, see
the equipment manual.
Store the engine level (normal operating position). Fill fuel tank (A, Figure 18) with fuel.
To allow for expansion of fuel, do not overfill above the fuel tank neck (B).
Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum deposits
to form in the fuel system or on essential carburetor parts. To keep fuel fresh, use Briggs
& Stratton Advanced Formula Fuel Treatment & Stabilizer, available wherever Briggs
& Stratton genuine service parts are sold.
There is no need to drain gasoline from the engine if a fuel stabilizer is added according
to instructions. Run the engine for two (2) minutes to circulate the stabilizer throughout the
fuel system before storage.
If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into
an approved container. Run the engine until it stops from lack of fuel. The use of a fuel
stabilizer in the storage container is recommended to maintain freshness.
Engine Oil
While the engine is still warm, change the engine oil. See the Change Oil section. For
Just Check & Add™ models, an oil change is not required.
Battery Pack and Charger
See Figure: 19
When not in use, disconnect charger and store in a cool, dry area. Wet, damp areas can
cause corrosion of terminals and electrical contacts. If stored for long periods in high
temperatures (120° F / 49° C), permanent damage to the battery pack can result. Check
electrical terminals and contacts on battery packs and charger. Wipe with clean cloth or
blow clean with compressed air.
After storage, a normal charge may be required. To check available charge, press the
Battery Fuel Gauge button (E, Figure 19) and charge if required. See the Battery Fuel
Gauge section.
Troubleshooting
For assistance, contact your local dealer or go to BRIGGSandSTRATTON.com or call
1-800-233-3723 (in USA).
Specifications
Model: 090000
Displacement
Bore
Stroke
Oil Capacity
Spark Plug Gap
Spark Plug Torque
Armature Air Gap
Intake Valve Clearance
Exhaust Valve Clearance
Model: 100000
Displacement
Bore
Stroke
Oil Capacity
Spark Plug Gap
Spark Plug Torque
9.15 ci (150 cc)
2.583 in (65,60 mm)
1.75 in (44,45 mm)
15 oz (,44 L)
.020 in (,51 mm)
180 lb-in (20 Nm)
.006 - .014 in (,15 - ,36 mm)
.004 - .008 in (,10 - ,20 mm)
.004 - .008 in (,10 - ,20 mm)
9.93 ci (163 cc)
2.668 in (68,28 mm)
1.75 in (44,45 mm)
15 oz (,44 L)
.030 in (,76 mm)
180 lb-in (20 Nm)
Model: 100000
Armature Air Gap
Intake Valve Clearance
Exhaust Valve Clearance

Lithium-Ion Battery

Lithium-Ion Battery Pack
Charge Minutes
Charging Current
Charger AC Input (Variable)
Operating Temperature
Engine power will decrease 3.5% for each 1,000 feet (300 meters) above sea level and
1% for each 10° F (5.6° C) above 77° F (25° C). The engine will operate satisfactorily at
an angle up to 15°. Refer to the equipment operator's manual for safe allowable operating
limits on slopes.
Service Parts - Models: 090000, 100000
Service Part
Air Filter (see Figure 16)
Air Filter, Pre-cleaner (see Figure 16)
Oil - SAE 30
Advanced Formula Fuel Treatment and Stabilizer
Resistor Spark Plug (Model 090000)
Resistor Spark Plug (Model 100000)
Spark Plug Wrench
Spark Tester
Lithium-Ion Battery Pack (US / Canada)
Lithium-Ion Battery Pack (EU / UK / AU)
Lithium-Ion Battery Charger (US / Canada)
Lithium-Ion Battery Charger (EU)
Lithium-Ion Battery Charger (UK)
Lithium-Ion Battery Charger (AU)
We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance
and service of the engine and engine parts.
Power Ratings: The gross power rating for individual gasoline engine models is labeled
in accordance with SAE (Society of Automotive Engineers) code J1940 Small Engine
Power & Torque Rating Procedure, and is rated in accordance with SAE J1995. Torque
values are derived at 2600 RPM for those engines with "rpm" called out on the label and
3060 RPM for all others; horsepower values are derived at 3600 RPM. The gross power
curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power values are taken
with exhaust and air cleaner installed whereas gross power values are collected without
these attachments. Actual gross engine power will be higher than net engine power and
is affected by, among other things, ambient operating conditions and engine-to-engine
variability. Given the wide array of products on which engines are placed, the gasoline
engine may not develop the rated gross power when used in a given piece of power
equipment. This difference is due to a variety of factors including, but not limited to, the
variety of engine components (air cleaner, exhaust, charging, cooling, carburetor, fuel
pump, etc.), application limitations, ambient operating conditions (temperature, humidity,
altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations,
Briggs & Stratton may substitute an engine of higher rated power for this engine.
Warranty
Briggs & Stratton Engine Warranty
Effective January 2017
Limited Warranty
Briggs & Stratton warrants that, during the warranty period specified below, it will repair or
replace, free of charge, any part that is defective in material or workmanship or both.
Transportation charges on product submitted for repair or replacement under this warranty
must be borne by purchaser. This warranty is effective for and is subject to the time periods
and conditions stated below. For warranty service, find the nearest Authorized Service
Dealer in our dealer locator map at BRIGGSandSTRATTON.COM. The purchaser must
.006 - .014 in (,15 - ,36 mm)
.004 - .008 in (,10 - ,20 mm)
.004 - .008 in (,10 - ,20 mm)
10.8 V (10,8 V)
60
2 AMP (2 AMP)
100 - 240 V
32 - 113° F (0 - 45° C)
Part Number
593260
594055
100005
100117, 100120
692051
594056
19576
19368
593559
593560
593561
593562
593576
594501
11