Caring For Your Iron After Use; Turning Off Your Iron; Storing Your Iron; Maintaining Your Iron - Sunbeam 3981 Manual Del Usuario

Caring for Your Iron After Use

T O
URNING FF
1. Turn the Steam dial to DRY and the Fabric Select dial to OFF.
2. Unplug the iron from the power source.
WARNING: NEVER yank the power cord when unplugging the iron,
this can damage the cord.
S Y
TORING OUR
1. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir
after each use for a longer iron life. To do so, open the water reservoir
cover and turn the iron upside down to allow water to flow from the
fill hole. Shake the iron gently to remove trapped water drops.
Close the water reservoir cover.
3. Loosely loop the power cord together and store the iron on its heel rest.
I : Wrapping the cord around the iron too tightly can damage
MPORTANT
the cord.
Tip: When not ironing, always set the Steam dial and the Fabric Select
dial to OFF.

Maintaining Your Iron

C
LEANING THE
Clean the soleplate if starch or other residue accumulate.
To clean the Soleplate:
1. Allow the iron to cool and then wipe it with a soft, damp cloth.
WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar
to clean the soleplate, this will damage the finish.
2. Run the iron over an all-cotton cloth to remove any residue.
Y I
OUR RON
I
RON
S
OLEPLATE
9 9 9