Identification Plate; Cabinet Requirements - Franke FH FS 864 Manual De Instalación

EN
FH FS 865 / FH FS 864 / FH FS 784 / FH FS 584
InstAllAtIon
Installation must be carried out in compliance with current standards and
regulations.
Installation must be only be carried out by specialized and licensed personnel.

Identification plate

The identification plate is located underneath the appliance.

Cabinet requirements

The images on page 5 represent recommended installation. If the dimensions are
different, any modifications are the responsibility of the installer.
The cooking hob is intended to be built into the worktop above a kitchen cabinet of
600 mm width or more.
If fitting in flammable material, the guidelines and standards for low voltage
installations and for the fire protection must be strictly observed.
For fitted units, the components (plastic materials and veneered wood) must be
assembled with heat-resistant adhesives (min. 100°C): Unsuitable materials and
adhesives can result in warping and detachment.
The kitchen cabinet must allow sufficient room for the electrical connections of the
appliance. Suspended kitchen cabinets above the appliance must be installed at a
distance that provides enough room for comfortable working process.
The use of hard wood decorative borders around the worktop behind the appliance
is allowed, in this case the minimum distance remains as indicated on the
installation illustrations.
The minimum distance between the built-in appliance and rear wall is indicated at
the illustration for the installation of the built-in appliance.
The appliance may be built into 35 to 65 mm thick worktops.
When installed above a drawer or cabinet the hob must be fitted with a horizontal
plate 20 mm away from the worktop's bottom surface. When installed above an oven
it is not necessary to add the horizontal plate. The space between the plate and the
appliance must be empty and no objects may be stored or kept inside it.
Incorporation of the oven under the appliance is permissible for ovens equipped with
a cooling fan.
– 8 –