Verification Procedure - KRATOS SAFETY FA 10 302 00 Manual De Instrucciones

on using each component in the system before use.
PERFORMANCE:
In accordance with regulation (EU) 2016/425, particularly in terms of the ergonomics of harmlessness, comfort of ventilation and flexibility; and
European standards EN 340 and EN ISO 20471, particularly in terms of luminescence and reflectivity (Class 2.2).

VERIFICATION PROCEDURE:

The equipment has a service life of 10 years (in accordance with the annual examination by a competent person authorized by KRATOS SAFETY), but
this duration may increase or decrease depending on how the harness is used and/or the results of annual checks.
The harness must be systematically checked if in doubt or after a fall, and at least every twelve months by the manufacturer or a competent person*, in
strict compliance with the manufacturer's periodic examination procedures (notably Inspection Guides ref. GI XXXXXXXX-XX), in order to ensure its
condition and therefore the safety of the user. The product data sheet should be completed (by writing) after each verification; date of inspection and date
of next inspection must be indicated on the data sheet, it is also recommended to put date of next inspection on the product.
*: please refer to the definition of a competent person on our website under the: Info/Technical advice section.
SERVICING AND STORAGE: (Comply strictly with these instructions)
Wash by hand (maximum 10 cycles); do not machine wash, washing temperature 30°C maximum.
No chlorination permitted. Do not iron. Steam treatment is expressly prohibited. Do not dry clean, do not use spot removing solvents. Do not dry in a
spin drier, leave to dry in the open air away from any heat source. Do not pre-soak. Do not use high alkalinity detergents, based on solvents, or micro
emulsion, or bleaching agent. Hang it up in a well-ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same
procedure for components that have become damp during use. The metal parts should be wiped with a cloth impregnated with paraffin oil.
During transport, keep the jacket harness in its packaging, well away from any cutting surface. The jacket harness should be stored in its packaging in a
warm, dry, ventilated place, protected from sunlight, heat and chemicals.
8