Cardin Elettronica S508 Manual De Instrucciones página 20

• Procedures that are carried out via USB using the programming base ignore the "PP" parameter
setting and will be carried out even if the 'rapid memorization function' has been disabled on the
receiver.
• To set up the new transmitter for rapid memorization, proceed as follows:
- Remove the upper cover from the transmitter to be memorised and from the transmitter that
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
has already been memorised as shown in the drawing below (det. a).
- Place the transmitter A, that has already been memorised in the receiver, beside the new
transmitter B (det. b).
- Using a pointed object press and release the MR button on both transmitter (in sequence or
simultaneously).
- The orange LEDS on the transmitters will flash slowly.
- Press and release a channel button on transmitter A that is already present in the receiver
(det. c).
- The led of the new unit B will remain lit for 3 seconds to confirm memorization (det. d).
Transmitter B will now command the receiver exactly like transmitter A.
1
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
MR
A
B
MR
A
20
All rights reserved. Unauthorised copying or use of the information contained in this do
B