sylvac D302 Manual Del Usuario página 55

EXT X[:Y]
Code
EXT ?
EXT A
'F'
F1..200
FAC RST
'G'
GEXT XY
GEXT ?
'I'
ID?
IN
'L'
L
L2
LCAL ?
LCAL dd.mm.yy
LCOR ?
LCOR dd.mm.yy
'M'
M
MAX
MAX ?
Actives the mode of the external contact. X = function, Y = channels
X = 1 : Print
X = 2 : Zero setting
X = 3 : Preset
X = 4 : Preset then Print
X = 5 : Reset of the Min/Max/Delta values
X = 6 : Turns on/off the continuous data output
X = 7 : Preset on Min value
X = 8 : Preset on Max value
Without Y : Selection of channels unchanged
Y = 0 : all activated channels or channels independent function
Y = 1 : channel 1
Y = 2 : channel 2
Y = 3 : channel 3
Y = 4 : channel 4
Y = 5 : channels 1 and 2
Y = 6 : channels 3 and 4
Y = 7 : 1st channel activated then next channel
Function
Returns the external contact mode (X:Y)
Actives the external contact of the RS-485 bus for 50ms
Selects the number of filtration samplings
General Reset (factory parameters)
Configures the external contact of the bus RS485. X : Input, Y : Output
X or Y = 0 : local contact on the module
X or Y = 1 : global contact sent on the bus RS485
Returns the configuration of the external contact of the bus RS485 (XY)
Returns the module identification (SY286 for D30X or SY286A for D30Xa)
Actives the Inch unit
Activates the data's memorization. Stops when memory is full or with command R or
with external contact. Command N is terminated.
Same as L but waits for the external contact to start the memorization
Returns the date of the last calibration of the module
Sets the date of the last calibration of the module
Sets the date of the last measuring correction
Reset the measuring correction
Enables the Min/Max mode. Disables with command D. Clears data's with command R
or external contact
Activates the Max measuring mode
Returns the Max measured value (if any of the modes Min/Max/Delta is activated)
55
A