Maxon 298905-01 Manual Del Usuario página 8

LIFT CORPORATION Sht. 8 of 58 DSG#
NOTE: Discard old fuseholder removed
from pump assembly.
3. Remove hex nut from starter switch
terminal where inline fuse holder is con-
nected (FIG. 8-1). Next, cut the RED
wire to relay assembly against the fuse
holder (FIG. 8-2). Then, reinstall hex nut
on starter switch terminal. Torque hex
nut to 30-35 lb-in maximum.
NOTE: Refer to cab switch wiring
diagram on FIG. 10-1.
4. Strip insulation from the RED wire
to install male bullet terminal (Kit
item). Then, crimp the male bullet
on the wire (FIG. 8-2).
© MAXON Lift Corp. 2020
RING
TERMINAL
OLD FUSE HOLDER
REMOVING FUSE HOLDER
RELAY ASSEMBLY
(REF)
16 GA MALE BULLET
(P/N 263345-01)
INSTALLING MALE BULLET
M-19-05
Rev. A Date: 10/14/20
WIRE CUT
RELAY
ASSEMBLY
STARTER
SWITCH TERMINAL
FIG. 8-1
FIG. 8-2
RED WIRE
RED WIRE