Getting Started; Batteries; Access Front Button Panel; Change Settings - Oregon Scientific BAR629HG Manual De Instrucciones

GETTING STARTED

BATTERIES

Batteries are supplied with this product:
• Main unit 3 x UM-3 (AA) 1.5V batteries
• Remote unit 2 x UM-4 (AAA) 1.5V batteries
Insert batteries before first use, matching the polarity
(+ and -) as shown in the battery compartment. For best
results, install batteries in the remote sensor before the
main unit. Press RESET after each battery change.
NOTE Do not use rechargeable batteries.
shows when batteries are low.
NOTE It is recommended that you use alkaline batteries
with this product for longer performance.
UNIT
Main
Remote
Installing the batteries:

ACCESS FRONT BUTTON PANEL

The front button panel is located inside the right portion
of the main unit. Slide it right to access the buttons.

CHANGE SETTINGS

To change, time, calendar and language settings:
1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press or to change settings. (To reach the
setting you want quickly, press and hold
3. Press MODE to confirm.
LOCATION
Indoor Temperature /
Humidity Area
Outdoor Temperature /
Humidity Area
or .)

TABLE STAND OR WALL MOUNT

Use the stand on the back of the main unit / remote
sensor, or mount it on a wall with a nail.
To attach the main unit stand:
To use the main unit wall mount:
To use the remote sensor stand or wall mount:

REMOTE SENSOR (THGR122NX)

This product is shipped with a THGR122NX Thermo /
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.

SETUP SENSOR

1. Open the remote sensor battery compartment with a
small Phillips screwdriver.
2. Insert the batteries, matching the polarity (+ and -) as
shown in the battery compartment.
4