Switch Clock Display; Alarm; View Alarm Settings; Set Alarm - Oregon Scientific BAR629HG Manual De Instrucciones

SWITCH CLOCK DISPLAY

Press MODE to toggle between Clock with Seconds and
Clock with Weekday display.

ALARM

This product is equipped with a 2-minute crescendo
alarm.

VIEW ALARM SETTINGS

Press . The alarm time and alarm status will show
in the Clock Area.

SET ALARM

1. Press to switch to alarm display.
2. Press and hold again for 2 seconds. The alarm
settings will blink.
3. Select the hour and minute. Press
settings. Press to confirm.

ACTIVATE ALARM

Press to activate or deactivate the alarm.
the Clock / Alarm Area when the alarm is activated.

SILENCE ALARM

When the alarm time is reached, the crescendo alarm
will sound for 2 minutes. To silence the alarm:
• Press SNOOZE / LIGHT to silence it for 8 minutes.
OR
• Press any key except SNOOZE to mute the alarm
and activate it again after 24 hours.
If no button is pressed, the alarm will automatically
silence after 2 minutes. It will then sound again after 8
minutes.

BAROMETER

This product tracks barometric pressure changes over
the past 24 hours to provide the weather forecast and a
trend line showing the direction of barometric change.
Barometric changes are measured by the main (indoor)
unit.

BAROMETRIC TREND

TREND
or to change
shows in
DESCRIPTION
Rising
Steady
Falling

SET UNIT AND ALTITUDE

You can set the barometric unit of measurement (mb /
hPa or inHg) and altitude. Doing this allows the product
to take more accurate barometric measurements.
1. Press PRESSURE to select the unit of
measurement: mb / hPa or inHg.
2. Press and hold PRESSURE for 2 seconds.
3. Select the altitude (-100 to 2500 metres) in
increments of 10). Press
setting. Press PRESSURE to confirm.

WEATHER FORECAST

This product forecasts the next 12 to 24 hours of weather
within a 30-50 km (19-31 mile) radius with 70 to 75
percent accuracy. The weather forecast is always
displayed.
SUNNY PARTLY
CLOUDY

TEMPERATURE AND HUMIDITY

This product can display current, minimum, and maximum
temperatures and humidity percentage information
collected by the remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every 40 seconds.
Indoor data is collected and displayed every 10 seconds.

SELECT TEMPERATURE UNIT

° °
Slide the C / F switch into the desired location. The
switch is located on the front button panel. The setting for
the main unit overrides the remote sensor setting.

SELECT CHANNEL NUMBER

Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
KINETIC-
WAVE
ICON
DESIG- Indoor
NATED Display
DISPLAY Channel 1 Channel 2 Channel 3
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEMORY.
NOTE If you use a sensor that collects only temperature
data, humidity will not be shown.
NOTE For more information on the sensor see "Remote
Sensor THGR122NX" Section.
6
or to change the
CLOUDY RAINY
Remote Remote Remote
Display Display Display