Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING WITH WALL FASTENERS (OPTIONAL)
1.
Using back plate as template, mark and drill center
holes into wall using 1/4" spiral masonry drill bit or 1/4"
wood drill bit (not included). (See Figure 4)
Figure 4
2. Install #10 x 1" anchors (not included) into drilled
holes, flush against surface. Insert type #10 x 1"
fasteners (not included) into four installation holes
in back plate, through installation tape. Tighten
fasteners securely. Be careful not to overtighten.
(See Figure 5)
Figure 5
LOADING DISPENSER AND USAGE
1. Open dispenser by pressing release button on
bottom and allow front cover to descend forward.
(See Figure 6)
PAGE 2 OF 6
INSTALLATION CONTINUED
2. Remove empty refill and recycle.
3. Remove fill cap and push the new refill into
4. Close dispenser cover.
5. Place hand in middle of bar and push several times.
1-800-295-5510
uline.com
Figure 6
dispenser until it clicks into place. (See Figure 7)
Figure 7
Product will dispense as bar is depressed.
(See Figure 8)
Figure 8
Bar
Cap
Refill
0921 IH-9593
Publicidad
