Rowenta DW7000 Manual De Instrucciones página 4

Ocultar thumbs Ver también para DW7000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
IMPORTANT RECOMMANDATIONS
• The voltage of your electrical installation must correspond to that of the iron (220-
240V). Always plug your iron into an earth socket. Connecting to the wrong voltage
may cause irreversible damage to the iron and will invalidate the guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated (16A) with
an earth, and is fully extended.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold it under the
water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when you are
ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your saftey, this appliance conforms to the applicable standards and regulations
(Low Voltage, Electromagnetic Compatibility, Environmental Directives).
• This product has been designed for domestic use only. Any commercial use,
inappropriate use or failure to comply with the instructions, the manufacturer accepts
no responsibility and the guarantee will not apply.
WARNING! For Iron models with anti-calc collector :
• Do not open and remove the anti-calc collector tray from the appliance during use.
• Only use the anti-calc collector tray that is supplied with the appliance. Do not use
other tray on the appliance.
• Do not fill water, perfume, vinegar, starch, descaling agents, ironing aids or other
chemicals at the channel of the anti-calc collector tray.
• Do not insert your finger or pointed objects into the channel of the anti-calc collector
tray.
Environment protection first !
i Your appliance contains valuable materials which can be recovered
or recycled.
 Leave it at a local civic waste collection point.
BEFORE USE
Warning ! Remove any labels from the soleplate before heating up the iron.
Warning ! Before using your iron with the steam function for the first time, we
recommend that you operate it in a horizontal position for a few moments,
away from your linen, i.e. press the Shot of Steam button a few times.
During the first few uses, a harmless odour and a small amount of smoke may
be given off.
This has no effect on the use of the iron and will disappear quickly.
1 • What water may be used ?
Your iron has been designed to operate using untreated tap water. If in doubt, check
with your local water authority. However, if your water is very hard, you can mix 50%
untreated tap water with 50% distilled or demineralised water.
IMPORTANT Heat concentrates the elements contained in water during
evaporation. The types of water listed below contain organic waste or mineral
elements that can cause spitting, brown staining or premature wear of the
appliance : water from clothes dryers, scented or softened water, water from
refrigerators, batteries or air conditioners, pure distilled or demineralised water
or rain water should not be used in your iron. Also do not use boiled, filtered or
bottled water.
IRONING BOARD: Due to the powerful steam output, a mesh type ironing
board must be used to allow any excess steam to escape and to avoid steam
venting sideways.
USE
2 • Filling the water tank
IMPORTANT Before filling the water tank, unplug the iron and set the steam
control to dry position
Tilt the iron. Open the filling inlet (fig.6). Pour in water up to the max mark (fig.7). Tilt
the iron. Open the filling inlet (fig.6). Pour in water up to the max mark (fig.7). Close
the filler inlet (fig.8) and return the iron to the horizontal.
Keep these instructions
.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido