Sanus VisionMount VMFL1 Manual De Instrucciones página 7

3
Wall Mounting - Drywall
3-1
Level wall plate [01] and mark hole locations
< 16 mm
(5/8 in.)
3-2
Drill pilot holes as illustrated
3-3
Tighten anchor bolts [04] only until the washer (W) is pulled fi rmly against the wall plate [01]
[04]
(W)
6901-002131 <00>
[01]
CAUTION:
lag bolt. To avoid potential injuries or property damage: pilot holes
MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 10 mm (3/8
in.) diameter drill bit.
CAUTION:
lag bolt. To avoid potential injuries or property damage:
The washer (W) must be between the anchor bolt [04] and the
[01]
wall plate [01].
DO NOT over-tighten the anchor bolts [04].
CAUTION:
Avoid potential personal injuries and
property damage!
Any material covering the wall must not exceed
16 mm (5/8 in.).
Do not install drywall anchors into the seam
between drywall pieces.
Improper use could reduce the holding power of the
63.5 mm
(2.5 in.)
Improper use could reduce the holding power of the
[01]
[04]
(W)
10 mm
(3/8 in.)
7