Power Supply; Troubleshooting - GYS NOMAD POWER 10 Manual Del Usuario

POWER SUPPLY

FLASHLIGHT FUNCTION
PROTECTIONS
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
TROUBLESHOOTING, CAUSES, REMEDIES

TROUBLESHOOTING

No response while pressing the ON/
1
OFF button
«Error» light ON on the jumper
2
cable.
«Error» light flashes red + alarm
3
beep.
The device is warm whilst connected
4
to a laptop.
10
NOMAD POWER 10
1 - Plug the auxiliary cable to PC port 19V 3.5A
2 - Select the appropriate connection for your laptop and connect it on the
auxiliary cable.
3 - Plug the auxiliary cable with the right connection on the power supply
socket of your laptop.
Press the ON/OFF button
Briefly press the button
mal, flash, SOS and OFF).
CAUSES
The NOMAD POWER is discharged.
Internal battery voltage < 11.0V.
Polarity reversal
Short-circuit
Clamps have been left connected to the battery.
-
for 3 seconds to turn on the LEDs.
to switch lighting modes (4 available modes: nor-
REMEDIES
Charge the product (see page 8).
Charge the product.
Check that the clamps are well connected and unplug/plug back the jumper
cable.
Check that the clamps are well connected and unplug/plug back the jumper
cable.
Remove the 2 clamps from the car battery in order to protect the device.
Remove laptop's battery or unplug the NOMAD POWER from the laptop for 5
minutes and plug it back again.
EN
of the NOMAD POWER.