Tabla de contenido
Publicidad
REAR PANEL
12. PHONES: For silent practice or late night playing just connect your favourite
headphones to the 3.5mm jack socket.
When headphones are connected, the internal loudspeakers are automatically
TIP
turned off.
13. AUX IN: Play along to your favourite tracks by connecting a MP3 player (or any other
line level device) using a stereo 3.5mm jack.
14.
FX LOOP: Gives you the option to route the pre-amp signal through an additional FX
unit. This could be in addition to or as an alternative to the onboard FX.
15. REMOTE: Connect an FS2-Mini (2-way) foot switch and independently control Reverb
and Chorus remotely.
RING: Chorus
TIP:
Reverb
16. D.I. OUT: This socket provides a balanced output for direct injection of the amplifier
signal into a mixing desk mic input. Using the Source switch, choose if the signal is Pre or Post
EQ, FX and Mute. Refer to the block diagram on page 8.
Finally, a ground lift switch is also provided to reduce the possibility of earth loop induced hum (when connecting to other
equipment).
17. EQ: This dual function switch allows you to select one of four pre-defined EQ curves allowing you to adjust the tonal
balance. To toggle from one to the next simply press the switch momentarily. An adjacent LED will clearly indicate what's
selected. The EQ setting will be stored in memory, ready for use next time.
Flat:
General purpose EQ setting - ideal for floor use.
Bass:
An increase in the low frequency content of your audio. Ideal when the A-Duo is pole mounted to compensate
for bass loss.
Loud: An increase in both low and high frequencies. Ideal for pole mounted use with added definition.
Vocal: Decreases the amount of bass and emphasises the vocal content. Also ideal for outdoors.
SUPPLY VOLTAGE:
POWER
FUSE RATING:
|
POWER CONSUMPTION 100 WATTS 50/60Hz
0
TIP
18. MAINS INLET AND POWER SWITCH:
A Universal mains input for worldwide usage without the need to change
anything except your power cord and fuse rating. The fuse rating will be
correct for the country in which the unit was sold. If used else where,
check the fitted fuse is of the correct rating. See information on A-Duo
rear panel.
The unit must be earthed under all circumstances!
Set Power switch to the off position (0) and disconnect the power
connector when the amplifier is not in use.
.
~100V-240V
T3.15A L 250V
A Spare fuse is stored
in the fuse tray.
EN
Note: the DI out level is nominal 500mV.
Floor mounted - vertical
Floor mounted - horizontal
(Badge can be rotated)
PHONES
AUX IN
FX SEND
FX RETURN
GND
GND
LIFT
USING THE A-DUO
Pole mounted
A-DUO
TIP - REVERB
RING - CHORUS
REMOTE
SOURCE
PRE
POST
D.I. OUT
CABINET
EQ
35MM
7
Publicidad
Tabla de contenido
