Publicidad
Idiomas disponibles
Idiomas disponibles
DM 2615302568 3/99
3/17/99 2:45 PM
Assembly and Operation Instructions
ATTACHMENT FOR USE WITH ALL ROTARY TOOLS, FLEX SHAFT TOOLS AND
HEAVY DUTY FLEX SHAFT TOOLS.
1. Assembly HEXAGON HEAD SCREW
thru housing allowing its HEXAGON
HEAD to fit into hexagon receptacle.
Secure with washer and CLAMP
KNOB. Leave loose for now. Tighten
after assembly of tubes. (Step 4)
2. Assemble the three Tubes to each
other. The center tube is reduced in
size at both ends. Rap the ends of the
tube assembly with a soft head
hammer to ensure a tight assembly.
3. The CORD HOLDER and hanger wire
bushing are one piece. Assemble this
part in one end of the tube assembly.
4. Insert the tube assembly, with the
CARD HOLDER up (away from clamp
screw) in the 5/8" hole in the clamp
housing. Let the tube extend below
the housing by a small amount, and
secure its location by tightening the
CLAMP KNOB.
5. Place the CLAMP HOUSING on a
work bench and secure by tightening
the CLAMP SCREW. Any bench can
be used with a thickness of 1-3/4" or
less. Screw holes are provided for
permanent installation. Use (3) #10 x
1-1/4" long FLAT HEAD WOOD
SCREWS: two from the front and one
from the top. Use this permanent
installation when possible. Pre-drill
with an 1/8" drill for maximum rigidity.
6. Assemble the rubber RETAINING
CAP on the HANGER WIRE. This cap
will keep the power tool hanger wire
contained on the hanger wire when
starting the motor. Insert the hanger
wire into the cord holder. Hanger wire
is free to rotate 360°.
Page 4
7. Hang a Moto-Tool with flex shaft
attachment or Moto-Flex tool on the
hanger wire. The Heavy Duty Moto-
Flex tool must be placed on the
outside. Height of the tool from the
bench can be adjusted using the
clamp knob. The Flex-Shaft Hanger
stand can accommodate two tools at
the same time. Push the power cord
into one of the slots on the rim of the
cord holder. Be sure to have some
slack in the cord to allow free
movement of the hanger wire.
8. Clamp housing has HOLES FOR
CUTTER and WRENCH STORAGE.
Holes for both 1/4" and 1/8" diameter
shanks are provided. A RING is
provided for controlling the hand
piece when not in use.
-4-
Publicidad
