Troubleshooting - Worx Jawsaw WG329E Manual Original

Keep Saw Chain sharp. Your saw will cut
faster and more safely. A dull Saw Chain will
cause undue Sprocket (16), Guide Bar (7), Saw
Chain, and motor wear. If you must force the
Saw Chain into wood and cutting creates only
sawdust with few large chips, then the Saw
Chain is dull.
LUBRICATING THE CHAINWHEEL
NOTE: It is not necessary to remove the chain
or bar when lubricating the chainwheel.
1. Clean the Guide Bar and chainwheel.
2. Using a grease gun, insert the tip of the
gun into the lubrication hole (h) and inject
grease until it appears at the outside edge
of the chainwheel tip (See Fig. Y).
3. You may need to rotate the chainwheel (i)
in order to grease all areas of the wheel.
To do this, pull the Saw Chain by hand to

TROUBLESHOOTING

If your saw does not operate correctly check the following:
Problems
Tool will not start.
Bar/chain overheated.
Chain is loose.
Poor cut quality.
Unit runs but does not cut.
Cordless Limbing and Trimming Chain Saw
rotate the chainwheel and align the parts
of the wheel that needs to be greased with
the lubrication hole. (See Fig. Y)
CLEANING
Regularly open the Chain Access Cover (9) and
remove any debris that has become trapped.
Regularly clean the ventilation slots with a
clean, dry paint brush.
To clean the tool, use only mild soap and a
damp cloth. Never let any liquid get inside the
tool and never immerse any part of the tool
into liquid.
TRANSPORTING
Always transport the tool with the Guide Bar
(7) and Saw Chain (8) inside the protection
guard.
Possible causes
Out of battery.
Chain too tight.
Lubrication needed.
Chain tension set incorrectly.
Chain tension set incorrectly.
Chain needs replacement.
Chain installed backwards.
See Fig H and illustration.
Possible solution
Charge the battery pack.
Refer to ADJUSTING THE
CHAIN TENSION section.
Refer to LUBRICATION
section.
Refer to ADJUSTING THE
CHAIN TENSION section.
Refer to ADJUSTING THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
Refer to sections for
CHANGING THE GUIDE
BAR AND CHAIN.
Refer to CHANGING THE
GUIDE BAR AND CHAIN
section.
19
EN