Bang & Olufsen BeoLab 4 PC Manual Del Usuario página 5

We recommend that you follow
this procedure:
– Disconnect your system from the
mains.
– Connect the loud speakers and set
the LINE IN MODE switch on
each loud speaker as explained in
'Cable connections' (pp. 6–7).
– Connect the entire system to the
mains again.
The loud speaker must be placed
standing upright on its base, or
fastened to one of the optional
accessories. Make the connections,
and set the switch before you
fasten the loud speaker to one of the
accessories.
Set up the loudspeakers
A
A
Loudspeaker front and side
panels
Each loudspeaker is equipped with
one front panel and two side panels.
These panels are fastened to the
loudspeaker with three small pegs
on the rear. The front panel is
marked with a Bang & Olufsen
name plate.
To remove the panels, for example
for cleaning, just pry the three
pegs in each panel free of the
corresponding holes (A–B) in the
loud speaker. Fasten the panels
again by inserting the three pegs
into the corresponding holes in
the front and the sides of the
loud speaker.
Note: The product identification
and CE labels are placed on the
loud speaker body behind the side
panels.
B
A B
5
B