Maintenance And Service; Maintenance And Cleaning - Bosch PSE 180 E Manual Original

OBJ_BUCH-746-001.book Page 19 Tuesday, March 17, 2009 10:45 AM
Special Application Tools
Universal Blade
SM 35 CS (2 608 691 098)
Steel, 35 mm, narrow, extra-sharp
especially for removing putty from
window joints or remainders from
door rabbets
Groove Scraper
SD 3 HM (2 608 691 112)
Carbide, 3 mm, narrow, with plastic
tile-protector
e.g. for removing of tiling grout from
tile joints
Holder for Bosch Replacement
Blades
SD 45 C (2 608 691 104)
Bosch Replacement Blades (45 mm)
SD 45 CE (2 608 691 140)
e.g. for removing paint and silicone
remainders from sensitive surfaces
such as tiles and glass
Wear protective gloves when
handling replacement blades!
Staple Remover
SD 8 C (2 608 691 116)
Steel, 8 mm, narrow
e.g. for removing staples and decora-
tion nails out of soft wood
Note: The staples are removed by the
stroke motion of the power tool. Do
not use the power tool for levering off!
Bosch Power Tools

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean the application tools from adhesive and
debris remainders each time after using.
Replacing the Dust Protection Cap
The dust protection cap 3 prevents the penetra-
tion of dust and debris into the tool holder 2 and
additionally serves as a no-load stroke stop.
The dust protection cap 3 can wear off with
time. Replace a damaged or worn dust protec-
tion cap immediately.
To replace the dust protection cap 3, insert a
slotted screwdriver with a slot width of
2 – 3 mm into the recess at the bottom housing
shell behind the dust protection cap, and re-
move the dust protection cap. Mount a new dust
protection cap ensuring that it is seated tightly.
Regrinding Steel Application Tools
Good working results can only be achieved with
sharp application tools. Therefore, resharpen
application tools in good time. This ensures a
long service life of the application tools and
good working results.
Regrinding with a Belt
Sander:
Mount the belt sander
into a stationary device.
Turn around the elec-
tric scraper with the
steel application tool
installed by 180°. Do
not start the electric
scraper.
Observe the running direction of the sanding
belt when regrinding.
1 609 929 N88 | (17.3.09)
English | 19