Product Specifications - Enerpac VFC3 Hoja De Instrucciones

CAUTION:
hydraulic hose. Avoid sharp
bends and kinks when routing
hydraulic hoses. Using a bent or kinked
hose will cause severe back-pressure.
Sharp bends and kinks will internally
damage the hose leading to premature
hose failure.
Do not drop heavy objects on
hose. A sharp impact may
cause internal damage to hose
wire strands. Applying pressure to a
damaged hose may cause it to rupture.
IMPORTANT:
hydraulic equipment by the
hoses or swivel couplers. Use
the carrying handle or other means of
safe transport.
CAUTION:
equipment away from flames
and heat. Excessive heat will
soften packings and seals, resulting in
fluid leaks. Heat also weakens hose
materials and packings. For optimum
performance do not expose equipment
to temperatures of 65°C [150°F] or
higher. Protect hoses and cylinders from
weld spatter.

PRODUCT SPECIFICATIONS

Fluid Temperature Range
Viscosity Range
Hydraulic Oil
Flow Rate
Operating Pressure
Back Pressure
Return Check Back Pressure
Weight
Avoid damaging
Do not lift
Keep hydraulic
–13° –176°F [–25° –80°C]
150–165 S.U.S. [15° –250c.St]
HLP 23 ISO 3448– 1975
427 cu. in/min. [7,0 L/M] Max.
5000 psi [350 bar] {35 MPa}
See Figure No. 3
See Figure No. 4
.5 oz. [15g]
DANGER:
pressurized hoses. Escaping oil
under pressure can penetrate
the skin, causing serious injury. If oil is
injected under the skin, see a doctor
immediately.
WARNING: Only use hydraulic
cylinders in a coupled system.
Never use a cylinder with
unconnected couplers. If the cylinder
becomes extremely
components can fail catastrophically
causing severe personal injury.
IMPORTANT:
equipment
serviced
hydraulic technician. For repair service,
contact the
Service Center in your area. To protect
your warranty, use only ENERPAC oil.
WARNING: Immediately replace
worn or damaged parts by
genuine
Standard grade parts will break causing
personal injury and property damage.
ENERPAC parts are designed to fit
properly and withstand high loads.
3.0 PRODUCT SPECIFICATIONS
2
Do not
overloaded,
Hydraulic
must only
by a qualified
Authorized ENERPAC
ENERPAC
Figure 1,
Hyd Schematic
handle
be
parts.