Verifying Proper Installation (Windows 2000) - Belkin F5U508 Manual Del Usuario

Installation
4. Once the computer has completely shut down, remove the computer's
5. Remove the port cover that corresponds with the PCI slot you wish to use.
6. Insert the PCI Card into the slot. Apply pressure as needed until the Card is
7. After installing the PCI Card, replace the outer cover and turn on the
EN
8. When Windows restarts, the PCI Card will be detected and all required
Note: Depending on the speed of your computer, it may take up to 30 seconds
for the PCI Card to be detected.

Verifying Proper Installation (Windows 2000)

After installation is complete, check the Windows Device Manager to confirm
that all components of the PCI Card have been properly installed.
1. Right-click on "My Computer".
2. Select "Properties".
3. Select the "Hardware" tab and click on the "Device Manager" button.
14
5248ea-A_F5U508ea.indb 14
cover and locate an empty PCI slot.
(The cover is usually held in place with a single screw).
fully seated. Secure the PCI Card with the screw removed in step 5.
computer.
drivers will be automatically installed. After the install is complete, you may
be prompted to click "Finish" and to restart your computer.
14/2/07 9:08:51 am