LUND I-20250 Manual De Instrucciones página 3

All vehicles without Tow Hooks
Remove the lower plastic portion of the bumper to gain access to the ends of the frame rails, (Figure
4). The lower bumper or splash guard will need to be cut out to allow the Mounting Brackets and end
of Bull Bar to pass through. On some models, access to the mounting hardware is limited. For
access, first remove the plastic bumper cover from each side of the opening and in the center of the
bumper, (Figure 5).
(Fig 4) Temporarily remove the splash
guard as required to gain access to the
front of the frame channel.
Vehicles without Tow Hooks and open end of frame
a. Starting on the driver side of the vehicle, insert (1) 12mm Bolt Plate through the opening in
the end of the frame and down through the rear hole in the bottom of the frame, (Figure 6A).
Thread (1) 12mm Flat Washer, (1) 12mm Lock Washer and (1) 12mm Hex Nut onto the end
of the Bolt Plate.
b. Slide the slotted end of the driver side Bracket under the nut and washers. Insert the second
12mm Bolt Plate through the remaining hole toward the front of the Mounting Bracket. Secure
the Bracket to the Bolt Plate with (1) 12mm Lock Washer, (1) 12mm Flat Washer and (1)
12mm Hex Nut, (Figure 6B).
c. Snug but do not tighten the hardware at this time.
d. Repeat to install the passenger side frame bracket.
(Fig 5) Remove bumper pads to access splash
guard hardware if necessary. 2015 F150 pictured
(Fig 6A) 12mm x 40mm Bolt
Plates
Insert Bolt Plates through
open end of frame
Fig 6B
Page 3 of 6
I-Sheet Number I-20250 Rev.A
REVOLUTION BULL BAR
(2) 12mm x 40mm Bolt Plates
(2) 12mm Lock Washers
(2) 12mm Flat Washers
(2) 12mm Hex Nuts
04-17 F-150
11/16/16