Remington I-LIGHT PRO IPL6000 Manual Del Usuario página 10

ENGLISH
Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants, perfume,
make up, lotions and creams. Shave the hair from the area to be treated.
2. Never use wax, epilation, tweezers, or depilation products to remove the hair
because they counteract the IPL process.
Prepare the device for treatment
3. Unwrap the hand piece cord from the i-Light base and rest the hand piece in the
base cradle. Locate the power switch on the i-Light base and ensure the unit is
OFF. Connect the power cord to the i-Light base at the power inlet. Connect the
power cord to the wall outlet. Turn the power switch ON (fig 6).
4. Use the skin sensor to unlock the unit.
You must unlock the unit on each body part you wish to treat.
5. Select the desired intensity level.
Treat desired area(s) with the i-Light device
The i-Light device is equipped with two operating modes: Single Flash Mode and
Multi-Flash Mode. Your i-Light device will automatically be set to Single Flash Mode each time the device is
powered ON.
Single Flash Mode: The i-Light device will flash once when the Flash Button is pressed AND the skin contact
sensor is engaged.
Multi-Flash Mode: The i-Light device will flash once every 2 seconds when the Flash Button is pressed AND
the skin contact sensor is fully engaged.
The Multi-Flash mode allows you to quickly treat large areas such as the legs, chest or back by simply gliding
the hand piece to a new location after each flash
10
IPL6000_IB_BOOK_1.indd 10
.
30/11/11 17:00:21