Remington I-LIGHT PRO IPL6000 Manual Del Usuario página 9

ENGLISH
WARNING: ALWAYS ensure the unit is OFF and the power cord is disconnected before
removing the nose cone. If the nose cone is removed while the unit is powered ON, all indicator
lights on the base unit will flash and audible "beeps" will sound.
Getting acquainted with i-light
Light Cartridge (fig. 1-15)
Each light cartridge has a life of 1,500 flashes. When all flashes have been used, the cartridge must be replaced.
Replacement model: SP-6000 SB
Intensity Level Selection (fig. 1-6)
The i-Light device is equipped with 5 intensity levels. Level 1 is the lowest setting and level 5 is the
highest setting.
TIP: For the most effective results, always use the highest intensity level that does not cause
discomfort on the skin. To determine the intensity level being used, observe the number of
lights illuminated on the Intensity Level Selection Display.
Your i-Light device will automatically be set to Intensity Level 1 each time the device is powered ON.
To change the level, press the Intensity Level Selection Button.
Test the i-Light device on your skin (fig. 5)
1. Review the Warnings and Safety Precautions.
2. Familiarise yourself with the features of the i-Light device.
3. Consult the Skin Tone Chart to ensure your skin colour is in the acceptable range.
4. Place skin of the intended treatment area on skin tone sensor( touching the skin tone sensor).
If your skin is suitable, the appliance will beep and switch on.
If your skin is unsuitable, the appliance will buzz and remain off.
5. Test the i-Light device on a small patch of skin and wait 48 hours to ensure there are no
adverse reactions.
IPL6000_IB_BOOK_1.indd 9
9
30/11/11 17:00:21