Remington I-LIGHT PRO IPL6000 Manual Del Usuario página 12

Ocultar thumbs Ver también para I-LIGHT PRO IPL6000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 72
ENGLISH
Post-treatment care
After treatment, you may experience slight redness or a warm sensation on your skin. This is normal and will
disappear quickly. To avoid irritation to your skin after a treatment, take the following precautions:
• Avoid sun exposure for 24 hours after a treatment. Protect the skin with SPF 30 for 2 weeks after each
treatment.
• Do not prolong sun exposure such as sunbathing, using a tanning bed, or self tan for at least 2 weeks
after the last treatment.
• After treatment, keep the area clean and dry and drink plenty of water to keep skin hydrated.
• Do not handle the treated area roughly.
• Do not take hot baths, showers, or use steam rooms and saunas for 24 hours after treatment.
• Do not swim for 24 hours after treatment.
• Do not take part in contact sports for 24 hours after treatment.
• Do not wear tight-fitting clothing over the treated area.
• Do not depilate (waxing, plucking, threading or creams) during the treatment – shaving is acceptable as
long as you avoid shaving 24 hours after each treatment.
• Do not use bleaching creams or perfumed products for 24 hours after treatment.
• Do not scratch or pick at the treated area.
Cleaning your device
Cleaning Your i-Light Device
CAUTION: Before cleaning your i-Light device, make sure that the power switch is OFF and the
power cord is disconnected from the base unit.
• Regular cleaning helps to ensure optimal results and a long life for the i-Light device. The exterior
surface of the base unit and hand piece may be wiped clean with a slightly damp cloth.
• To clean the Flash Window, use only the lint-free cloth included with your i-Light device. Take care not
to scratch or chip the Flash Window. Scratches and chips can reduce the effectiveness of the unit.
• For stubborn stains, use a dampened cotton swab to apply a small amount of water to the Flash
Window and clean with the lint-free cloth provided.
• Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch
the filter glass or the metallic surface inside the Nose Cone.
CAUTION: The i-Light is a high voltage device. Never immerse in water. Never clean the unit or
any of its parts under the tap or in the dishwasher.
12
IPL6000_IB_BOOK_1.indd 12
30/11/11 17:00:21

Publicidad

Tabla de contenido
loading

Tabla de contenido