geberit ECO 203 Operación Manual página 31

Fault
Red LED lights up
Pressing tool stops
and no LED lights up
Red and green LEDs
flash alternately
B1279-001 © 02-2016
966.996.00.0 (00)
Cause
Pressing tool is
overloaded
Non-permissible
pressing systems
are being used
Mains voltage is
too low
Pressing tool is
defective
Power failure
Maintenance
interval has been
reached
Action
Release start button
Press and hold release button: roller
drive moves to its starting position
Repeat the pressing operation:
press the start button for approx.
2 seconds
Release start button
Press and hold release button: roller
drive moves to its starting position
Only use permissible pressing
systems
Have the pressing tool tested by an
authorised repair shop
Check the mains voltage
Fully unreel the cable drum of the
extension cable
Reduce extension
After a network failure, press and
hold release button: roller drive
moves to its starting position
Have the pressing tool tested by an
authorised repair shop
Release start button
Press and hold release button: roller
drive moves to its starting position
Examine the pressfitting for
tightness and repeat the pressing
operation if necessary
Have the pressing tool tested by an
authorised repair shop
EN
31