Installation Preparation - GE JGRP20 Instrucciones De Instalación

TOOLS YOU WILL NEED
Drill with 1/8" Bit
Adjustable Wrench
Pipe wrench
3/16" Hex Socket
Driver
#1 or #2
Phillips Screwdriver
MATERIALS YOU MAY NEED
Gas line Pipe joint sealant
shut-off valve
FOR FLEXIBLE CONNECTION WHERE
LOCAL CODES PERMIT:
• Coated and approved flexible metal tubing (same
• Adaptor or connector
FOR RIGID CONNECTION:
• Pipe fittings or union as required
2

Installation Preparation

Safety Glasses
Ruler
Pencil
12" Spirit Level
Hand Saw
1/2" pipe nipple
1
GAS REQUIREMENTS
You must follow local codes when installing your
built-in oven. Check with your local utilities for
codes and ordinances that apply in your area.
If there are no local codes, you must follow the
National Fuel Gas Code ANSI/Z223.1 – Latest
Edition. To get a copy write to:
American Gas Association
1515 Wilson Boulevard
This standard does not cover the thermal
efficiency of household cooking gas appliances
since it is regulated by the Energy Policy and
Conservation Act of 1975, the National Energy
Conservation Policy Act of 1978 and the National
Appliance Energy Conservation Act of 1987.
If the oven is to be installed in a mobile home,
the installation must conform to the Manufactured
Home Construction and Safety Standard, Title
24, CFR, Part 3280 or, when not applicable, the
Standard for Manufactured Home Installations
ANSI/ A225.1 – Latest Edition and Manufactured
Home Installations, Sites and Communities ANSI/
NFPA 501A, or with local codes. You can get a
copy of the Federal Standard by writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010.
2
ELECTRICAL REQUIREMENTS
This appliance must be electrically grounded.
Check with your local codes which apply in
your area. If no local codes apply, the National
Electrical Code, ANSI/NFPA No. 70 – Latest
Edition must be followed. Write to:
NATIONAL FIRE PROTECTION
ASSOCIATION
BATTERYMARCH PARK
QUINCY, MA 02269
31-2000792 Rev. 0