MAKE THE LP GAS CONVERSION
WARNING
If you are using LP (bottled) gas,
all the adjustments described below must be made
before you make any burner adjustments or use
the oven.
WARNING
This conversion must be
performed by a qualified installer or gas supplier
in accordance with the manufacturer's instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions
could result in serious injury or property damage.
The qualified agency performing this work
assumes responsibility for the conversion.
NOTE: Disconnect all electrical power and turn off the
gas supply at the shut-off valve before beginning the
conversion.
1
ADJUST PRESSURE REGULATOR
FROM NATURAL GAS TO LP
A. Remove the Regulator Cover Plate at the back of
the storage drawer area by removing 2 screws.
B. Locate the regulator.
Pressure Regulator
with Built-In Shut-Off
Valve
C. Unscrew the cap.
Gasket
Nat
NAT.
8
Installation Instructions
Regulator
Cover Plate
Adaptor
Flexible
Connection
FLEXIBLE HOOK-UP
Fig. 11
Cap
Spring
Retainer
LP
l..P.
Fig. 12
1
ADJUST PRESSURE REGULATOR
FROM NATURAL GAS TO LP
(Cont.)
D. Remove the retainer from the cap.
E. Turn the retainer over so LP is showing on the
bottom of the retainer.
F. Return the retainer inside the cap.
G. Replace the cap on the regulator.
H. Replace the Regulator Cover Plate using the 2
screws that held it originally.
2
ADJUST BURNER ORIFICE FROM
NATURAL TO LP GAS
CAUTION
The adjustments in the next
column must be made before turning on the
burners. Failure to do so could result in serious
injury due to high flames and toxic fumes.
Your Broil burner is located in the upper portion of
the oven and is easilly accessible.
To access your Bake burner follow the steps
below:
A. Open the oven door.
B. Remove the oven bottom.
C. Remove 4 screws holding the oven baffle (flame
Oven Bottom
Burner Baffle
D. Remove the orifice fitting cover.
Air Shutter
Air Shutter
Screw
Fig. 13
Orifice
Fitting
Cover
Fig. 14
31-2000792 Rev. 0