GE JGRP20 Instrucciones De Instalación página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL THE OVEN (Cont.)
8
CHECK THE BURNER FLAMES FOR
NATURAL GAS
The oven is factory-adjusted for use with Natural Gas
in most areas. But, since the gas in some areas may
vary, you should check all adjustments described
below. If you are to use LP Gas, see LP Adjustments
at the back of this guide.
NOTE: Bake and broil flame must be checked with the
door closed to properly check flame characteristics. To
properly check the bake burner, the oven bottom and
oven baffle must be removed.
Turn on the bake or broil burner.
As you watch the flame with the oven door
closed, check the following through the oven door
window:
1. Burner flames should not flutter or blow away
from the burner.
2. T hey should be blue in color with no trace of
yellow.
3. The inner cone of the flame should be
BURNERS SHOULD BE CHECKED FREQUENTLY.
9
MAKE THE BURNER FLAME
ADJUSTEMENT
BAKE BURNER
A. Open the oven door.
B. Remove the oven bottom.
C.
Oven Bottom
Burner Baffle
D. Remove orifice fitting cover.
Air Shutter
Air Shutter
Screw
6
Installation Instructions
Fig. 9
Orifice
Fitting
Cover
Fig. 10
9
MAKE THE BURNER FLAME
ADJUSTMENTS (Cont.)
E. Use a screwdriver to loosen the air shutter screw.
1. If the flames were yellow, open the air shutter
more than the original setting.
2. If the flames blew away or fluttered from the
burner, close the air shutter more than the
original setting.
F. Make the adjustment.
G. Retighten the air shutter screw.
H. Close the door and recheck the flame.
When the results are satisfactory:
1. Replace the orifice fitting cover.
2.
3. Replace the oven bottom.
BROIL BURNER
A. The broil burner is located and accessible in the top
rear of the oven.
B. Use a screwdriver to loosen the air shutter
adjustment screw.
1. Check air shutter to ensure it's in the fully open
position and clear of any obstructions. For NG
application ensure that the regulator is in the NG
position. For LP applications ensure that the hood
has been tightened to the LP position.
2. If the flames blew away or fluttered from the
burner, close the air shutter more than the
original setting.
C. Make the adjustment.
D. Retighten the air shutter screw.
E. Close the oven door and recheck the flame.
31-2000792 Rev. 0

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jgrp20wejwwJgrp20bejbbJgrp20senss

Tabla de contenido