Tape Mode - Elta 2322USB Manual De Instrucciones

MP3-CD playback
1. Set the function selector (8) to CD/USB. The POWER LED (4) lights up and the display shows DISC and
no.
2. Press OPEN/CLOSE (11) to open the door of the CD drive on the top of the unit.
3. Insert a MP3-CD with the printed side facing up and close the door of the CD drive manually.
4. The display shows three dashes "- - -" for a few seconds and subsequently the total number of tracks.
5. Press (7) on the unit or PLAY/PAUSE on the remote control to start playback of the first track.
6. Press (7) on the unit or PLAY/PAUSE on the remote control to pause playback. Press
PLAY/PAUSE again to resume playback.
7. To select the next or previous folder, repeatedly press
on the remote control until the unit shortly displays ALBUM and the folder number. Now you are located
in the next / previous folder on the MP3-CD. Press FOLDER UP (13) on the unit or remote control to
immediately skip to the next folder on the CD.
8. Press (17) on the unit or
USB mode
1. Set the function selector (8) to CD/USB. The POWER LED (4) lights up and the display shows DISC and
"no"
2. Press CD/USB button (9) on the unit to turn on USB mode. The display shows USB and "no".
3. Now connect a USB device to the USB port.
4. The display shows three dashes "- - - " for a few seconds and subsequently the total number of tracks
that are read from the USB device connected to the USB port.
5. Press (7) on the unit or PLAY/PAUSE on the remote control to start playback of the first track.
6. Press (7) on the unit or PLAY/PAUSE on the remote control to pause playback. Press
PLAY/PAUSE again to resume playback.
7. To select the next or previous folder, repeatedly press
on the remote control until the unit shortly displays ALBUM and the folder number. Now you are located
in the next/ previous folder on the USB device. Press FOLDER UP (13) on the unit or remote control to
immediately skip to the next folder on the USB device.
8. Press CD/USB (9) to turn back to CD mode. After a few seconds you can remove the USB device from
the USB port.

TAPE MODE

Before operating the cassette deck, make sure the function selector is set to tape mode.
Cassette tape playback
1. Set the function selector (8) to position TAPE(OFF). The POWER LED (4) and the display are turned off.
2. Press STOP/EJECT (22) to open the cassette deck.
3. Correctly insert a cassette tape into the tracks of the cassette deck door with the playing side facing the
window and the tape band facing down.
4. Carefully close the door by pushing it forward (inside). Check beforehand that the tape band is wound up
tight.
5. Press PLAY/► (22) to start playback. The tape plays from left to right.
6. You can stop playback at any time by pressing STOP/EJECT/
playback stops automatically and the unit simultaneously releases the PLAY/► button (22).
7. After pressing STOP/EJECT
backwards or forwards.
(16) or
/STOP on the remote control to stop playback.
(16) or
(22) press REW (22) or F. FWD
(7) or
(6) on the unit or – SKIP or SKIP +
(7) or
(6) on the unit or – SKIP or SKIP +
(22). When the tape reaches the end,
(22) to wind up the tape
21.