19
Take out the Insulating Strip
• Open the battery door in the back of the scale.
• A new set of batteries had been installed in the battery compartment according to the correct polarity.
Please just remove the plastic strip before first use. Take out the insulating strip along the direction(-
shown on insulating strip).
• Close the battery door and wait until the digits "0.0" are shown on the LCD.
Replace the Batteries
• Open the battery door in the back of the scale.
• Insert the batteries (2x CR2032) into the battery com-
partment according to the polarity indications marked
inside the compartment.
* The digits 8888 will be shown on the LCD.
• Close the battery door and wait until the digits "0.0" are
shown on the LCD.
CAUTION
• When the symbol "Lo " appears, the device will power off soon. Then you shall replace with a new
set of batteries. Please replace both two batteries at the same time. Do NOT mix the old batteries
with the new one.
• Worn batteries are hazardous waste. Do NOT dispose of them together with the household gar-
bage. Please refer to the local ordinances and recycling instructions regarding disposal of the
worn batteries and scrapped device.
• If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the
batteries before storing.
• Please properly keep the micro battery, in case the children swallowed.
ENGLISH
Open the battery door
Direction of the 2
CR2032 batteries