Start-Up - Stanley FatMax Tru Laser Measurement TLM300 Manual De Empleo

D
Multifunctional Endpiece
GB
See figure {D}
F
The device can be used for different measurement
situations:
I
• For measurements from an edge open the posi-
tioning bracket until it locks in place. See figure
E
{F}.
• For measurements from a corner, open the posi-
P
tioning bracket until it locks in place, with a slight
NL
push to the right the bracket can be turned
further. See figures {D and F}.
DK
A built-in sensor automatically detects the orienta-
tion of the positioning bracket and calculates the
S
corresponding distances accordingly.
N
Integrated telescopic viewfinder
FIN
The device is equipped with a telescopic viewfinder
on the right hand side. The viewfinder is especially
J
helpful when aiming at distant targets. When looking
through the viewfinder, the target is clearly visible
CN
thanks to the 2x magnification. At distances beyond
30 m the laser spot is centered on the crosshair,
ROK
below 30 m the laser spot appears on the edge of the
crosshair, which is normal.
PL
Level
HR
The integrated bubble level allows simple horizontal
H
levelling of the instrument.
RUS
CZ

Start-up

GR
Keypad
See figure {A}:
1 ON/MEASURING
2 MEASUREMENT REFERENCE
3 AREA
4 VOLUME
5 ROOM ANGLE
6 TRAPEZOID MEASUREMENT
7 PLUS [+]
8 EQUAL [=]
9 MENU
10 UNITS
11 CLEAR/OFF
12 MINUS [-]
13 INDIRECT MEASUREMENT PYTHAGORAS
14 RECALL/MEMORY
15 HISTORY/TIMER
Display
See figure {C}
1 Information about faulty measurement
2 Laser "Active"
3 Roof length
4 Measurement reference
5 Maximum value of continuous measurement
6 Roof pitch (angle)
7 Minimum value of continuous measurement
8 Trapezoid area
9 Recall of historical storage
2
Stanley TLM 300 1.0.0 gb