Output Connections; Controls And Operational Features - Saf-Fro PRESTOMIG 185MP Manual De Instrucciones

Output Connections

Refer to points [7], [8] and [9] of the Figures below.

Controls and Operational Features

1. LED Indicator Power switch (only
PRESTOMIG
lights up when the welding machine is
ON and is ready to work
Figure 1
2. Thermal Overload Indicator: It indicates that the
machine is overloaded or that the cooling is not
sufficient. Depending on:
PRESTOMIG
insufficient is shown by lighting LED under
the symbol.
PRESTOMIG 210MP: The message
as image is shown by the display
[13].
3. Process Welding's Switch:
GMAW (MIG/MAG) process
Warning: Can be used to FCAW-SS
process.
SMAW (MMA) process
WARNING
When the machine is switched again on, last welding
process will be recalled.
WARNING
If the push-button is pushed in GMAW process in, the
output terminals will lived.
WARNING
During SMAW process, the output terminals are still lived.
English
185MP): This LED
185MP: Overload or
4. Knob Control: Depending on welding process, this knob
controls:
GMAW
process
SMAW
process
5. WFS/Hot Start Control: Depending on welding process,
this knob controls:
GMAW
process
SMAW
process
6. Welding Load Voltage / Current Knob Control:
Depending on welding process, this knob controls:
GMAW
process
SMAW
process
7. EURO Socket: For connecting a welding gun (for
GMAW / FCAW-SS process).
8. Positive Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
9. Negative Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
10. Left Knob: The value of parameter in the upper left side
of display [13] is adjusted.
11. Right Knob: The value of parameter in the upper right
side of display [13] is adjusted.
12. Set Knob: Type of welding procedure and welding
settings is changed by this knob.
13. Display: Parameters of welding process are shown.
14. User Button (left): Button function could be set:

Advanced menu:

Recalls advanced menu (default)

Recalls user memory.

Inductance.

Run-in WFS.

Burnback.

Basic menu – changes basic menu for advanced menu.
9
Inductance: Arc control
controlled by this knob. If the
value is higher, the arc will be
softer and during welding is less
spatters.
ARC FORCE: The output current
is temporarily increased to clear
short circuit connections between
the electrode and the workpiece.
Wire feed speed WFS: Value in
percentage of nominal value wire
feed speed.
HOT START: Value in percentage
of nominal value welding current
during arc start current. The
control is used to set the level of
the increased current and arc start
current is made easy.
The welding load voltage and set
by this knob [6] (also during
welding).
The welding current is set by this
knob [6] (also during welding).
is
English