Technical Data; First Use And Charging The Batteries - therm-ic Heated Beanie Modo De Empleo

(2.1) - back
 Charge indicator (2.2)
 Charging cable with plug (2.3)
TECHNI CA L DATA
Charger (accessory available from Therm-ic)
 Input: 100 – 240V (50-60Hz)
 Output: 1 x 4.2 V / 1.0 A
Lithium-ion battery (accessory available from
Therm-ic)
 3.7 V / 1300 mAh
FI RST US E AND CHARGI NG THE
B A T T E RIE S
The battery must be charged before using it for the
first time.
1. Plug the charger into a socket. The charge
indicator (2.2) will light up in green. Afterwards
11
plug the battery into the charger. The load
process will start automatically and the charge
indicator (2.2) will light up in red during charging.
2. The charging time is approximately 2 to 2.5
hours.
3. Once the battery has been fully charged, the
charging process is automatically concluded and
the LED on the charge indicator (2.2) will go
back to green.
4. Disconnect the battery from the charger.
5. Connect the battery back with the hat (engage
connectors).
Important note:
 Recharge the battery after each use. This will
protect the batteries and ensure your Therm-ic
Heated Beanie is always ready for use.
 The battery consists of lithium ion cells and can
be charged in any state. It is therefore
unnecessary to fully discharge the battery before
charging.