Aux Operations; Trouble Shooting - Clarion CZ202E Manual De Instrucciones Y De Instalación

iPod & iPhone Operations
Random play
This function allows you to play all tracks
recorded on a disc in a random order.
1. Press [ 3 ] button repeatedly until "ALBUM
RDM" appears on the LCD for album random
play.
2. Press the [ 3 ] button once or more until
"SONG RDM" appears on the LCD to
perform random play.
3. Press [ 3 ] button repeatedly until "RDM
OFF" appears on the LCD to cancel
random playback.
Setting iPod simple control mode
Use this function if you wish to operate
through your iPod connected to this unit via
the USB cable.
* The factory default setting is " OFF ".
1. Press and hold [DISP] button to enter
system setup.
2. Press [ ] or [ ] button to select
" S-CTRL".
3. Rotate the [VOLUME] knob to select
" ON " or " OFF " .
• ON: Operations are made through your
iPod.
• OF F: Op erations cannot be m ade
through your iPod.
Notes:
• When performing iPod operations using
simple control mode, make the operations
s l o w l y . I f r e p e t i t i v e o p e r a t i o n s a r e

AUX Operations

Press [SRC / ] button on the panel to select
"AUX".
AUX is just for audio content with 3.5mm Jack
connector plugged into audio-in socket on the
front panel.
AUX Input sensitivity setting
1. Press and hold the [DISP] button (1 sec.).
9
CZ202E/CZ202ER/CZ202EG
performed too quickly, unforeseen errors
may occur.
• When performing iPod operations using
simple control mode, please do not
operate the iPod and the unit at the same
time, otherwise there may be unexpected
event happened.
• Some iPod models do not support this
function. Consult your nearest Clarion
dealer or website to confirm which models
do not support this function.
iPod menu alphabet search
This function searches the subfolders for
desired alphabetical letters.
1. Press the [MENU] button to select the iPod
menu mode.
2. Press the [VOLUME] knob to switch
between categories.
MUSIC: PLAYLIST, ARTISTS, ALBUMS,
GENRES, SONGS, COMPOSERS
VIDEO: MOVIES, MUSIC VIDEOS, TV
SHOWS VIDEO PODCASTS, RENTALS
3. Press the [VOLUME] knob. (The contents
of the category are displayed.)
4. Press and hold the [ DISP ] button (1 sec.).
5. Rotate the [VOLUME] knob to select the
desired letter to search.
6. Press the [DISP] button again to next
perform search.
7. Press the [ VOLUME ] knob to confirm.
2. Turn the [VOLUME] knob to select "AUX
SENS".
3. If the output level of connected external
audio player is "HIGH", rotate [VOLUME]
knob and choose "LOW". And if the
output level is "LOW", choose "HIGH".

6. TROUBLE SHOOTING

GENERAL
Problem Cause
Unit fuse blown.
Unit can not
power on.
Car battery fuse blown.
Unit can not
power on.
Nothing happens
The microprocessor has
when buttons are
malfunctioned due to noise, etc.
pressed.
Display is not
accurate.
Improper audio output
connection.
Volume set too low.
No/low audio Speakers damaged.
output.
Heavily biased volume balance. Adjust the channel balance to center
Speaker wiring is in contact with
metal part of car.
Non-standard disc used.
Speaker power rating does not
Poor sound
match unit.
quality or
distortion.
Wrong connections.
Speaker is shorted.
Tel-Mute
MUTE wire is grounded.
malfunction.
Unit resets itself
Incorrect connection between
when engine
ACC and Battery.
is off.
Measure
Replace with new fuse of correct rating.
Replace with new fuse of correct rating.
Turn off the power and remove the DCP.
Press the [RESET] button with a thin rod.
Note:
When the [RESET] button is pressed, turn
off the ACC power.*
* When the [RESET] button is pressed,
preset radio stations, titles, etc. stored in
memory are kept.
Check wiring and correct.
Increase volume level.
Replace speakers.
position.
Insulate all speaker wiring connections.
Use a standard disc.
Replace speakers.
Check wiring and correct.
Check wiring and correct.
Check the MUTE wiring and correct.
Check wiring and correct.