6871916T01.book Page 5 Tuesday, March 8, 2016 9:48 AM
Charging Instructions
1. Make sure the radio is Off.
2. Plug the power supply into an electric outlet.
3. Connect the power supply output cord connector into the rear
of the Desktop Charging Tray.
4. The LED on the charger blinks green once to indicate charger
is turned on.
5. Insert the radio into the pocket of the Desktop Charging Tray.
If the battery is being charged separately, insert the battery
into the back pocket of the Desktop Charging Tray.
6. The charger's LED color will indicate the battery charging
status. (See table below).
LED Color
Solid Red
Blinking Red
Solid Green
Blinking Green
Single Blink Green
Blinking Yellow
Charging Status
Charging
Battery Fault
Charge Complete
Top-off Charging
Power On
Waiting to Charge
5