Mantis Elite - Vision Engineering Mantis Guia Del Usuario

Packing Contents
Universal mount
G-clamp
Counter balanced boom stand
Viewing head
Power adapter
Objective lens
Anti glare hood
Assembly
1
Secure the universal mount to the work surface using
the G-clamp provided or by using appropriate
screws located in the counter bored holes of the
Mount.
2
Place the universal arm on top of the universal
mount. Lower onto spigot until fully mounted.
3
Loosen the upper retaining bolt
the lower retaining bolt
head's locating hook
arm.
Replace the lower retaining bolt, ensuring the
bolt passes through the lower locating mount
of the Mantis viewing head.
Tighten the upper and lower retaining bolts then
re-seat the universal arm rubber gaiter
4
Fit the chosen objective lens
objective seat (ensuring the Vision logo is at the
front) and tighten the securing screw
required, rotate the objective turret
another objective lens in the same way.
5
Ensuring the power adapter is suitable for your supply voltage, connect the power adapter plug to a suitable power
outlet and its output connector to the base of the universal arm.
6
Connect the output lead at the top of the universal arm to the rear of the viewing head.
Do not attempt to connect the power supply directly to the viewing head.
Routine Maintenance
Desiccant Replacement
The desiccant removes excess moisture from the optical head.
Disconnect the power supply from the bottom of the head.
Remove the grommet
desiccant.
Insert the new desiccant and replace the grommet.
LED Arrays
The method for removing the LED arrays is identical for either side.
Disconnect the power supply from the bottom of the head.
Loosen the two screws
remove the cover.
Lift out the LED array
remove the LED array complete with filter
Reassembly is the reverse of this procedure.
www.visioneng.com/support
on the universal arm. Remove
. Carefully place the Mantis viewing
over the upper retaining bolt of the universal
.
into the
. If
and fit
covering the desiccant and remove the
that secure the filter/array cover
and turn it over. Disconnect the array connector
.
and
and
Mantis Elite with Universal Stand - User Guide

MANTIS ELITE

9