4/Installation; Installation Area; Removing The Transport Bolts - Selecline MFE50-JU806 Manual De Utilización

4/ INSTALLATION

4.1 Installation area

Warning!
The product must be placed in a stable location to prevent
it from moving during use.
Ensure that the appliance is not standing on the power
cord.
Before installing the machine, follow the steps below to select a
suitable location:
1. Choose a stable, dry, and level surface.
2. Avoid direct sunlight.
3. Ensure that there is sufficient ventilation.
4. Ensure that the room temperature is above 0°C.
5. The installation location must be far away from flammable
materials such as coal or gas.
4.2 Unpacking the washing machine
Warning!
Packaging material (e.g. film, polystyrene foam) can be
dangerous for children.
Risk of suffocation! Keep all packaging materials out of the
reach of children.
1. Remove the cardboard box and polystyrene foam.
2. Lift the washing machine and remove the base packaging.
Make sure the small triangular foam is removed together
with the bottom piece. If not, lay the unit down on its side,
and then remove the small piece of foam from the bottom
of the unit.
3. Remove the tape securing the power supply cord and drain
hose.
4. Remove the inlet hose from the drum.

4.2.1 Removing the transport bolts

Warning!
Before using the product, the transport bolts must be
removed from the rear side of the appliance.
Keep the transport bolts in a safe place for future use (you
will require these if you need to transport the appliance to a
new location).
Follow the steps below to remove the bolts:
1. Loosen the 4 bolts with a spanner and then remove them.
2. Stop the holes with the transport hole plugs.
3. Store the transport bolts in a safe place for future use.
16